Still haven t found the problem.
Furnace circuit breaker problems.
Go to your home s breaker panel and.
A bad circuit breaker can be causing the furnace breaker to be tripping.
This can be caused by a number of reasons.
If the machine doesn t power on check the circuit breaker.
As a result shorts and other issues might occur therefore tripping the circuit breaker.
Here s the next step in furnace troubleshooting.
Failed time delay relay.
2 be sure the furnace s circuit breaker is on or that its fuse has not blown.
Check both the main electrical panel and any secondary subpanels that supply power to the unit.
If the fan doesn t run try resetting the furnace circuit breaker.
Not enough power from the thermostat to the furnace.
Overload due to loose electrical connection.
Can be caused by a bad wire or by power not reaching the thermostat.
Or replace the fuse.
Next check the outside condensing unit.
Another reason why your breaker is tripping is a faulty furnace motor.
If the circuit has blown or tripped reset the circuit breaker by flipping it all the way off and then on again.
Your furnace may be tripping the circuit breaker because of one of these reasons.
Don t keep resetting the breaker to turn the furnace back on until you fix the underlying problem.
Try turning the fan to on using the fan switch on the thermostat to test for power to furnace.
No power from the rvs battery to the furnace relay switch.
Other issues that can contribute to an overworking furnace blower include home air leaks duct leaks and closed or blocked off air registers.
Check the ssu switch it looks like a light switch on a gray box located at the furnace to be sure it is in the on position.
Overload due to furnace blower overworking.
This problem can be avoided by simply scheduling for regular hvac maintenance.
Ensure that there is power to the furnace.
There are issues with your furnace motor.
Let s explain the above problems in more detail.
If the furnace fan kicks in the problem isn t in the furnace.
Common rv furnace problems rv furnace blower won t start.
The fix is to replace the breakers.
Check the circuit breakers at the electrical panel.
If the fan still won t start call a pro the fixes shown here won t work.
Short circuits in your furnace happen when a bare hot wire comes in contact with a neutral wire.
Breakers do go bad from time to time and cause nuisance trips.
Unless you know what you are doing this will require the services of an electrician or hvac technician.
A furnace that starts up but immediately trips the breaker can be caused by an electrical short circuit or ground fault inside of the furnace itself.
The compressor which sounds like a refrigerator and fan should be running.
The system s wiring usually wears down after years of use.